Lampada orale a LED a induzione per poltrona odontoiatrica

 

 

 

 

(1) toggle switch dimming

There are 8 levels of brightness adjustment in total (digital display is 08 / 10 / 12 / 14 / 16 / 18 / 20 / 22, which represents the illumination level from low to high). Slide the toggle switch right and hold on for 1-2 seconds, start the stepless dimming function. When the brightness is adjusted to the maximum or minimum brightness, the reverse dimming will be started if you continue to keep the toggle state. When the proper brightness is reached, just release the toggle switch.

(2)  Induction dimming Palm stays in the sensing area for 1-2 seconds, starts the dimming mode, when the brightness is adjusted to the maximum or minimum brightness, the reverse dimming will be started if you continue to keep the palm in the sensing area. When the proper brightness is reached, just put your palm down.

 

2. Turn on/off the anti-cure mode:

Slide the toggle switch left to turn on the anti-cure lighting mode. In this case, the blue component of the light is filtered out and the composite material can be used for a long

time. Slide right to normal operation mode.

 

3. Both sides of the outer handle, press the top of the Bowen button to pull out, the handle can be removed, easy to clean and disinfect.

 

1. Non-mirror area cleaning can be carried out with three gun gas, or it can be cleaned with soft cotton flannel or wet paper towel;

2. The reflective cup can be cleaned with glasses cloth (to disable rough feeding to prevent scratching the surface).

Note: All surfaces of the lamp should not be wiped clean with corrosive liquids!